Signs Your Garage Door Spring Is Broken (and What to Do)
The loud bang, the gap in the coil, the door that will not lift: how to recognize a broken garage door spring, why it is dangerous, and what to do until a technician arrives.

Most homeowners meet their garage door spring for the first time on the day it breaks. Here is how to recognize it, why you should leave the door alone, and what happens next.
What a garage door spring does
A sectional garage door can weigh anywhere from well over a hundred pounds to several hundred. The spring system, usually one or two torsion springs on a shaft above the door, counterbalances that weight so the door feels light and the opener only has to guide it. When a spring breaks, that balance is gone. The door suddenly weighs what it really weighs, and nothing in the system is designed to lift it.
Signs your garage door spring is broken
A loud bang from the garage
The classic sign. A torsion spring releasing its tension sounds like something heavy hit the floor. Often it happens overnight or while the door is closed.
The door lifts a few inches, then stops
The opener's force limit trips because the door is too heavy. Some openers will reverse or flash a fault.
A visible gap in the coil
Look above the door at the spring on the shaft. A broken torsion spring shows a clear separation, usually an inch or two, somewhere along its length.
Cables hanging loose or wrapped wrong
When the spring lets go, the cables often jump off the drums and dangle or tangle on one side.
The door feels impossibly heavy by hand
With the opener disconnected, a balanced door lifts with one hand. A door with a broken spring will not budge or feels like dead weight.
The door is crooked or slammed down
On two-spring doors, one failing spring can let one side drop. A door that crashes closed is another warning sign.

What to do right now
- Stop using the opener.Running the motor against a broken spring strips gears and can bend the top section of the door.
- Do not pull the red release cord with the door up.Without the spring holding it, the door can slam down.
- Keep people, pets and cars clear.Especially if the door is crooked or partly open.
- Call us.Tell us whether a car is trapped. We offer same-day service and will give you a realistic arrival window.
Please do not attempt this repair
A torsion spring is wound under enough tension to cause serious injury if it slips during removal or installation. The job needs winding bars, the correct spring size and practice. Our technicians do it every day; it is not a weekend project.
What the repair involves
A technician clamps the door, confirms the spring's wire size, inside diameter and length, and checks the cables, drums and bearings. Remaining tension is released safely, the old hardware comes off, and new springs and cables sized to the door go on. On a two-spring door we recommend replacing both, because the surviving spring has the same wear and will fail soon anyway. The door is then balanced by hand and the opener's force and limits are reset.
Most residential spring replacements are completed in a single visit with parts carried on the truck. If your door uses an uncommon spring size, we will tell you right away and order it.
How to make the next set last
Springs are rated in cycles. A door opened and closed four or five times a day wears through a standard rating in a handful of years. Two things help: have the springs lubricated during a yearly tune-up so the coils do not rust and bind, and ask about high-cycle springs when you replace. They cost a little more and last considerably longer.
Talk to a Nabors technician.
Phones are answered 24 hours a day. Same-day service is available across Lake Norman, Charlotte and the Triad.
(704) 870-0548 Request an Estimate